Clutch C

DISASSEMBLY 

Courtesy of CHRYSLER GROUP, LLC

Courtesy of CHRYSLER GROUP, LLC

1. Place the C-clutch (2) in a suitable press.
2. Using (special tool #8680A, Installer, Damper) (1), compress the C-clutch (2) as needed to remove the snap ring (3).
3. Remove the snap ring (3).

   Courtesy of CHRYSLER GROUP, LLC

4. Remove the C-clutch retainer (1).

   Courtesy of CHRYSLER GROUP, LLC

5. Remove the C-clutch piston (1).

   Courtesy of CHRYSLER GROUP, LLC

6. Remove the belleville spring (1).

   Courtesy of CHRYSLER GROUP, LLC

7. Remove the wave plate (1).

   Courtesy of CHRYSLER GROUP, LLC

8. Remove the six friction plates (2) and the six steel plates (3).

   Courtesy of CHRYSLER GROUP, LLC

9. Remove the backing plate (1).

   Courtesy of CHRYSLER GROUP, LLC

10. Separate the clutch shaft (3) from the clutch hub (1).

    Courtesy of CHRYSLER GROUP, LLC

11. Remove two O-rings (2) from the C-clutch shaft (1).

ASSEMBLY 

Courtesy of CHRYSLER GROUP, LLC

1. Replace the C-clutch seals (2) on the C-clutch shaft (1).

   Courtesy of CHRYSLER GROUP, LLC

2. Install C-clutch hub (2) onto the C-clutch shaft (1).

   Courtesy of CHRYSLER GROUP, LLC

3. Install the backing plate (1).

   Courtesy of CHRYSLER GROUP, LLC

4. Install six friction plates (2) and six steel clutch plates (3).

   Courtesy of CHRYSLER GROUP, LLC

5. Install the wave plate (1).

   Courtesy of CHRYSLER GROUP, LLC

6. Install the belleville spring (1).

   Courtesy of CHRYSLER GROUP, LLC

7. Install the C-clutch piston (1).

   Courtesy of CHRYSLER GROUP, LLC

8. Install the C-clutch retainer (1).

   Courtesy of CHRYSLER GROUP, LLC

9. Place the C-clutch (2) in a suitable press.
10. Using (special tool #8680A, Installer, Damper) (1), compress the clutch enough to install the snap ring (3).
11. Install the snap ring (3).
12. Using (special tool #8901A, Pressing Tool) and (special tool #10429, Gauge, Force) measure the C-clutch clearance, Refer to clutch clearance chart for specifications.