Clutch A
WARNING: This page is about a different variant/trim than selected.
DISASSEMBLY
| 1 - A CLUTCH SNAP RING |
| 2 - A CLUTCH SUPPORT PLATE |
| 3- A CLUTCH FRICTION PLATES |
| 4- A CLUTCH WAVE SPRING |
| 5- A CLUTCH STEEL PLATE |
| 6- A CLUTCH WAVE PLATE |
- Remove the oil pump from the transmission case. Refer to
PUMP, TRANSMISSION OIL, REMOVAL AND INSTALLATION .
- Remove the B- Piston cushion spring (1).
- With one hand above B-Piston (1), carefully apply air pressure into the hole directly above the B-Piston alignment tab to remove B-Piston (1) from the assembly.
- Remove the snap ring (1).
- Remove the clutches and spacers (2).
- Remove the hub (1).
- Position the oil pump housing assembly (3) in a suitable press (2).
- Using (special tool #8285, Compressor, Spring) (1) press on the fingers of the piston retainer to remove tension on the split retaining ring.
- Remove the two halves of the retaining ring (1).
- Remove the wave spring (1).
- Remove the A- Piston (1) from the housing.
- Remove and DISCARD the A- Piston seals (1, 2).
ASSEMBLY
NOTE:
If the clutch discs are being replaced, soak in 8HP transmission fluid before assembly.
- Insert the piston into the housing with NEW
piston seals (1, 2). Lubricate the seals with transmission assembly lube prior to installing them into the housing.
- Insert the wave spring (1).
- Position the oil pump housing assembly (3) in a suitable arbor press (2).
- Using (special tool #8285, Compressor, Spring) (1), press on the fingers of the piston retaining ring to remove tension.
- Install the two retaining ring halves (1).
- Install the hub (1).
- Install the clutches and wave springs (2).
- Install the snap ring (1).
- Install a NEW
B-Piston seal (1).
- Install the B-Piston (1) on the assembly.
- Install the B-Piston cushion spring (1) on the B-Piston.
- Install the transmission oil pump. Refer to PUMP, TRANSMISSION OIL, REMOVAL AND INSTALLATION .