LEMON Manuals: Even more car manuals for everyone
Home >> Alfa Romeo >> 2021 >> Stelvio Ti >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (2.9L - Engine (Service Information)) >> Turbocharger System >> Cooler And Hoses, Charge Air >> Removal And Installation >> Left Turbocharger Surge Valve

Left Turbocharger Surge Valve

WARNING: This page is about a different variant/trim than selected.

REMOVAL 

  1. Disconnect and isolate the negative battery cable.
    GC0080051Courtesy of CHRYSLER GROUP, LLC
  2. Remove the flexible hose (1) from the cold air intake tubes.
    GC0175051Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the left turbocharger air by-pass solenoid wire harness connector (1).
  4. Remove the bolts (2a) and the left turbocharger air by-pass solenoid (2b) complete with O-ring.

INSTALLATION 

  1. Using a NEW  O-ring, install the left turbocharger air by-pass solenoid and securely tighten the bolts.
  2. Connect the left turbocharger air by-pass solenoid wire harness connector.
  3. Install the flexible hose onto the cold air intake tubes.
  4. Connect the negative battery cable.
scientia non olet · About LEMON Manuals