Gap And Flush: Specifications
ADJUSTMENT OF MOVING PARTS
Measurements for the adjustments of moving parts
To facilitate and verify moving parts disassembly and assembly operations, the existing gaps are shown (in millimeters) to allow appropriate adjustment.
The adjustment procedure is explained in the sections describing moving part removal and installation procedures in the service information.
 Courtesy of CHRYSLER GROUP, LLC
|
 Courtesy of CHRYSLER GROUP, LLC
|
 Courtesy of CHRYSLER GROUP, LLC
|
 Courtesy of CHRYSLER GROUP, LLC
|
 Courtesy of CHRYSLER GROUP, LLC
|
 Courtesy of CHRYSLER GROUP, LLC
|
 Courtesy of CHRYSLER GROUP, LLC
|
 Courtesy of CHRYSLER GROUP, LLC
|
 Courtesy of CHRYSLER GROUP, LLC
|
 Courtesy of CHRYSLER GROUP, LLC
|
 Courtesy of CHRYSLER GROUP, LLC
|
 Courtesy of CHRYSLER GROUP, LLC
|
 Courtesy of CHRYSLER GROUP, LLC
|