Body - Interior & Exterior: Caution: Cautions

Work carefully on the trim details and use the recommended tools correctly to prevent damage.

Before working on the electrical system (connectors, electrical components, wiring, etc.) turn the ignition key to STOP and disconnect the battery.

The battery terminals must only be disconnected with the ignition key at STOP or extracted, never with the key at MAR (Accessory/On/Run) or with engine started. The battery terminals must only be disconnected at least 1 minute after turning the ignition key to STOP and having closed the driver side door to prevent the hydraulic system pressurization stage, which starts when the door is opened, from being interrupted before its completion.

When reconnecting the cables, also make sure the driver's door is closed.

All mounting screws for components (structural and nonstructural) mounted to the carbon chassis, outside the car, are made of stainless steel. The use of mounting elements in other materials may induce "galvanic" corrosion. Therefore, when installing, take particular care to reuse (or replace if applicable) mounting elements with the characteristics described above.