Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read DTCs.
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - Test complete.
CHECK THE CAN LINE WIRING BETWEEN THE INSTRUMENT PANEL CLUSTER AND THE TIRE PRESSURE MODULE
1. Check that the CAN connections between the Instrument Panel Cluster (IPC) and the Tire Pressure Module (TPM) are not faulty. In particular, that there are no open circuit or short circuit problems.
  Were there any faulty conditions?
  
  Yes
  - Restore or, if necessary, replace the wiring.
  No
  - Go To 3
CHECK THE INSTRUMENT PANEL CLUSTER CONNECTORS
1. Disconnect / reconnect the IPC connectors and check for loose pins
  Were there any loose pins found?
  
  Yes
  - Restore the connector to a correct working order.
  No
  - Go To 4
CHECK THE TIRE PRESSURE MODULE CONNECTORS
1. Disconnect / reconnect the TPM connectors and check for loose pins
  Were there any loose pins found?
  
  Yes
  - Restore the connector to a correct working order.
  No
  - Go To 5
CHECK THE INSTRUMENT PANEL CLUSTER POWER SUPPLY
1. Check that the power supply to the IPC is correct.
  Is the power supply to the IPC correct?
  
  Yes
  - Go To 6
  No
  - Restore the correct power supply.
CHECK THE TIRE PRESSURE MODULE POWER SUPPLY
1. Check that the power supply to the TPM is correct.
  Is the power supply to the TPM correct?
  
  Yes
  - Go To 7
  No
  - Restore the correct power supply.
CHECK THE INSTRUMENT PANEL CLUSTER
1. Check that the IPC is operating correctly.
  Is the IPC operating correctly?
  
  Yes
  - Go To 8
  No
  - Replace the Instrument Panel Cluster (IPC) in accordance with the Service Information. Refer to REMOVAL AND INSTALLATION .
CHECK THE TIRE PRESSURE MODULE
1. Check that the TPM is operating correctly.
  Is the TPM operating correctly?
  
  Yes
  - Test complete.
  No
  - Replace the Tire Pressure Module (TPM) in accordance with the Service Information. Refer to MODULE, TIRE PRESSURE MONITORING (TPM), REMOVAL AND INSTALLATION .