Recommended Carbon Fiber Cosmetic Clay Bar Procedure:

Before removing any defects, wash the effected area with soap and water.
Work in a 305 mm (12in) x 305mm (12in) area at a time and apply Meguiars Final Inspection or a detail spray equivalent to the effected area.
Using Mequiars Mild Detailing Clay C2000 or equivalent, work in a unidirectional pattern while the detail spray applied in is still wet. Refer to 2.
NOTE:
Do not move the clay bar in a circular direction on the panel surface, it will create scratches.
If the defect cannot be removed using a clay bar, proceed to the carbon fiber cosmetic finishing procedure.