R_H/L_HI Shorted Wire Inspection - For DTC B108E

Test Procedure 

• Preparation
• • -

    Relay control module connector B (10P): disconnected

• Procedure
• • -

    Perform the inspection according to the following table.

    Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.

(Disconnected)Relay control module connector B (10P) female terminals

IG Mode

Courtesy of HONDA, U.S.A., INC.

Normal Conditions

R_H/L_HI shorted to ground inspection 

OFF

Not shorted 

Results 

• If abnormal, there is a problem in the circuit.
• If normal, there is a problem with the relay control module.