SRS - SRS Indicator Does Not Come "On"
NOTE:
- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed .
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information .
- Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS unit software , and retest.
- Problem verification
-1. Press the engine start/stop button to select the OFF mode, then wait for 10 seconds.
-2. Press the engine start/stop button to select the ON mode, and check that the SRS indicator comes on for about 6 seconds.
Does the SRS indicator come on for about 6 seconds?
YES
Intermittent failure, the vehicle is OK at this time.
NO
The failure is duplicated. Go to step 2.
- Gauge control module check
-1. Press the engine start/stop button to select the OFF mode.
-2. Connect the HDS to the data link connector (DLC) .
-3. Press the engine start/stop button to select the ON mode.
-4. Do the gauge control module self-diagnostic function .
Self diagnostic function
Does the SRS indicator blinkΩ
YES
NO