How to Read Deployed History
NOTE:
Due to the amount of electrical current that flows within the SRS unit to deploy airbags and tensioners, the SRS unit will be severely damaged and will require replacement. Therefore, the SRS unit retains a history that indicate which airbags and tensioners that deployed in a collision. Airbags and tensioners that deployed cannot be reused and must be replaced.
1. Turn the vehicle to the OFF (LOCK) mode, then wait for 10 seconds.
2. Connect the HDS to the data link connector (DLC).
3. In the SRS MENU of the HDS, select SRS, then select Data List.
NOTE:
When any airbags or tensioners have deployed, go to Component Replacement/Inspection After Deployment .
| Signal |
|---|
| Left front airbag, left side curtain airbag, and/or left front seat belt tensioner deployed |
| Right front airbag, right side curtain airbag, and/or right front seat belt tensioner deployed |
| Left side airbag, left side curtain airbag, and/or left front seat belt tensioner deployed |
| Right side airbag, right side curtain airbag, and/or right front seat belt tensioner deployed |
4. Turn the vehicle to the OFF (LOCK) mode, then wait for 10 seconds.
5. Disconnect the HDS.