LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2022 >> ILX >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System (SRS) - Service Information (Except Hybrid) >> Removal And Installation >> Cable Reel >> Installation

Cable Reel: Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:
  • Before installing the steering wheel, make sure the front wheels are aligned straight ahead.
  • New cable reel is locked by yellow tab for center adjustment. When installing a new cable reel there is no need to rotate the cable reel. You remove the tab and discard it, after install new cable reel.
  1. Cable Reel - Install
    GHH475149Courtesy of HONDA, U.S.A., INC.
    		 1. Position the two tabs (A) of the steering angle sensor (B) as shown. Install the cable reel (C) to the steering angle sensor.
  2. Cable Reel/Steering Angle Sensor - Install
    GHH475150Courtesy of HONDA, U.S.A., INC.
    		 1. Install the cable reel/steering angle sensor (A).
  3. Cable Reel Connectors A, B, and Steering Angle Sensor Connector - Connect
    GHH475151Courtesy of HONDA, U.S.A., INC.
    		 1. Connect cable reel connectors A and B on the dashboard wire harness, and the steering angle sensor connector (C).
  4. Column Cover - Install
    1. Install the upper and lower column covers .
  5. Cable Reel - Align
    GHH475152Courtesy of HONDA, U.S.A., INC.
    		 1. Make sure the front wheels are pointing straight ahead.

    2. Center the cable reel (A). Do this by first rotating the cable reel clockwise until it stops.

    3. Rotate the cable reel counterclockwise about three full turns. The arrow mark (B) on the cable reel label should point straight up.
  6. Steering Wheel - Install
    GHH475153Courtesy of HONDA, U.S.A., INC.
    		 1. Position the steering wheel hub (A) so that it engages the pin (B) of the cable reel.

    2. Install the steering wheel (C) on to the steering column shaft.

    NOTE: Do not tap on the steering wheel or the steering column shaft when installing the steering wheel.
  7. Cable Reel Connector C - Connect
    Fig 1: Steering Wheel Bolt With Torque Specifications
    GHH475154Courtesy of HONDA, U.S.A., INC.
    1. Install the new steering wheel bolt (A).

    2. Connect cable reel connector C on the cable reel subharness to the cable reel (B).

    3. A/T: Slide and install the connector (D) to the bracket (E), then connect the paddle shifter + (upshift switch) connector (F).

    4. A/T: Install the harness to the holder (G).

    5. Make sure the wire harness is routed and fastened properly.
  8. Driver's Airbag - Install
    1. Install the driver's airbag .
  9. Battery Terminal - Connect
    1. Do the battery terminal reconnection procedure .
  10. DTC - Clear
    1. Clear any DTCs with the HDS.
  11. SRS Operation - Confirm
    1. Press the engine start/stop button to select the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.
  12. VSA Sensor Neutral Position - Memorize
    1. Do the VSA sensor neutral position memorization .
  13. Steering Angle Sensor Neutral Position - Clear
    1. Do the steering angle sensor neutral position clear .
scientia non olet · About LEMON Manuals