DTC P2B08, P2B09, P2B0A, P2B0B (1.5 L Engine) (2021)
DTC P2B08 : No. 1 Cylinder Injector (Split injection control monitoring)DTC P2B09 : No. 2 Cylinder Injector (Split injection control monitoring)DTC P2B0A : No. 3 Cylinder Injector (Split injection control monitoring)DTC P2B0B : No. 4 Cylinder Injector (Split injection control monitoring)
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | Confirmed DTC | Pending DTC |
|---|---|---|
| P2B08 No. 1 Cylinder Injector (Split injection control monitoring) | ||
| P2B09 No. 2 Cylinder Injector (Split injection control monitoring) | ||
| P2B0A No. 3 Cylinder Injector (Split injection control monitoring) | ||
| P2B0B No. 4 Cylinder Injector (Split injection control monitoring) |
DTC (PGM-FI)
- Problem verification
-1. Let the engine cool until the value of ECT Sensor 1 is 77 deg.F (25 deg.C) or less.
Signal Current conditions Values Unit ECT Sensor 1 -2. Clear the DTC with the HDS.
-3. Start the engine, and let it idle for 10 seconds or more.
-4. Monitor the OBD STATUS for DTC P2B08, P2B09, P2B0A, and P2B0B in the DTCs MENU with the HDS.
DTC Description Confirmed DTC Pending DTC P2B08 No. 1 Cylinder Injector (Split injection control monitoring) P2B09 No. 2 Cylinder Injector (Split injection control monitoring) P2B0A No. 3 Cylinder Injector (Split injection control monitoring) DTC Description Confirmed DTC Pending DTC P2B0B No. 4 Cylinder Injector (Split injection control monitoring) Does the HDS indicate FAILED?
YES
The failure is duplicated. Replace the PCM .
NO
If the HDS indicates PASSED, intermittent failure, the system is OK at this time. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot . If the HDS indicates NOT COMLETED, go to step 1-1 and recheck.