DTC P0130 (1.5 L Engine)

WARNING: This page is about a different car, the 2022 Honda Accord, 2021 Honda Accord, 2020 Honda Accord, 2019 Honda Accord, and 2018 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.

DTC P0130 : A/F Sensor (Sensor 1) Out of Range

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC Description	Confirmed DTC	Pending DTC
P0130 A/F Sensor (Sensor 1) Out of Range

DTC (PGM-FI)

Problem verification

-1. Turn the vehicle to the ON mode.

-2. Clear the DTC with the HDS.

-3. Start the engine. Hold the engine speed at 3, 00 rpm without load (CVT in P or N, M/T in neutral) until the radiator fan comes on, then let it idle.

-4. Monitor the OBD STATUS for DTC P0130 with the HDS.

DTC Description	OBD STATUS
P0130 A/F Sensor (Sensor 1) Out of Range

Does the HDS indicate FAILED?

YES

Replace the A/F sensor (Sensor 1) .

If the HDS indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot . If the HDS indicates EXECUTING, keep idling until a result comes on. If the HDS indicates OUT OF CONDITION, go to step 1-3 on this step and recheck.