DTC P101A (1.5 L Engine)
WARNING: This page is about a different car, the 2022 Honda Accord, 2021 Honda Accord, 2020 Honda Accord, 2019 Honda Accord, and 2018 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.
DTC P101A : VTC B Advance Malfunction
NOTE:
- Before you troubleshoot, review the general troubleshooting information .
- If DTC P0366 is stored at the same time as DTC P101A, troubleshoot DTC P101A first, then recheck for DTC P0366.
- If DTC P101A set after replacing the VTC actuator, verify that the correct timing marks on the crankshaft pulley were used.
| DTC Description | Confirmed DTC | Pending DTC |
|---|---|---|
| P101A VTC B Advance Malfunction |
DTC (PGM-FI)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Start the engine.
-4. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC P101A VTC B Advance Malfunction Is DTC P101A indicated?
YES
Go to step 2.
NO
Intermittent failure, the system is OK at this time. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot .
- VTC oil control solenoid valve B operation check
-1. Turn the vehicle to the OFF (LOCK) mode.
-2. Test VTC oil control solenoid valve B .
Is the solenoid valve OK?
YES
Go to step 3.
NO
- VTC actuator B check
-1. Inspect VTC actuator B .
Is the actuator OK?
YES
Check the VTC system oil passages and clean them if needed.
NO