P083C, P083D (A/T)
DTC P083C : Transmission Fluid Pressure Switch A Circuit Low
DTC P083D : Transmission Fluid Pressure Switch A Circuit High
NOTE: Before you troubleshoot, review the General Troubleshooting Information .
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P083C Transmission Fluid Pressure Switch A Circuit Low | |||
| P083D Transmission Fluid Pressure Switch A Circuit High |
DTC (A/T)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Test-drive under these conditions:
DTC Test Condition P083C - Start the engine.
- While pressing the brake pedal, shift the transmission to D position/mode, and wait for several seconds.
P083D Start the engine, and wait for several seconds in P position/mode. -4. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P083C Transmission Fluid Pressure Switch A Circuit Low P083D Transmission Fluid Pressure Switch A Circuit High Is DTC P083C or P083D indicated?
YES
The failure is duplicated. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good TCM , then recheck. If this DTC goes away and the TCM was substituted, replace the original TCM .
NO
Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals between the transmission fluid pressure switch and the TCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.