Moonroof Frame And Drain Tube: Installation: Notes
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
- Before installing the frame, clear the drain tubes and the drain valves using compressed air.
- To install a new drain tube, tie the string left in the body during drain tube removal to the top end of the new drain tube, and pull it up into the roof.
- When connecting the drain tubes, slide them over the frame nozzles at least 10 mm (0.39 in).
- Check the frame seal.
- When installing the frame, first attach the rear hook into the body holes.
- Install the tube clips (A) on the drain tubes (B) as shown.