Moonroof Drain Channel Slider And Cable Assembly: Installation

NOTE: Before reinstalling the motor, make sure both link lifters are parallel, and in the tilt up position.

Drain Channel Slider and Cable Assembly - Install

Courtesy of HONDA, U.S.A., INC.

1. Apply multipurpose grease to the glass brackets (A) and the guide rail area of the frame (B) indicated by the arrows.

Courtesy of HONDA, U.S.A., INC.

2. Install the cable assembly (A) and both glass brackets (B) to the frame (C).

3. Install both deflector sliders (D) to both glass brackets.

Courtesy of HONDA, U.S.A., INC.

4. Install the drain channel slider (A).

5. Repeat on the opposite side.

Courtesy of HONDA, U.S.A., INC.

6. Install the cable assembly (A).

7. Install both glass brackets (B) with the link lifters (C).

8. Turn both cable tube side brackets (D) down to install the hooks (E) to the holes in both sides of the frame.

Courtesy of HONDA, U.S.A., INC.

9. Install the screws (A, B, C) and the bolt (D).

10. Repeat on the opposite side.