DTC U3000-51 (SRS Unit): Notes

DTC U3000-51 : SRS Unit Programming Error

NOTE:

Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components of the correct part number and were properly installed - Refer to: SRS Component Replacement/Inspection After Deployment .
This DTC is indicated when the SRS unit update is not completed properly.
Never press the engine start/stop button while updating the SRS unit. If you press the engine start/stop button before you complete the SRS unit update procedure, the SRS unit can be damaged. If there is a problem with the update, keep the vehicle in ON mode.
Before doing this troubleshooting procedure, review SRS Precautions and Procedures and How to Troubleshoot .