Right Rear Seat Belt Tensioner Inspection
Before disconnecting the SRS related connector, do the 12 volt battery terminal disconnection procedure and wait for at least 3 minutes.
NOTE:
Since there is no direct method to test the component itself, troubleshooting is performed on the related components.
Test Procedure
Right rear seat belt tensioner circuit inspection
- Preparation
- Right rear seat belt tensioner 2P connector: disconnected
- Procedure
- Install a jumper wire between right rear seat belt tensioner 2P connector terminals No. 1 and No. 2.
- Perform the confirmation procedure.
(Disconnected)
Right rear seat belt tensioner 2P connector female terminals
- Normal Conditions
- DTC B0075-13 is not indicated.
Results
- If it is normal, there is a problem with the right rear seat belt tensioner.
- If it is abnormal, there is a problem with the related components.