Driver's Seat Belt Buckle Switch Inspection
NOTE:
Since there is no direct method to test the component itself, troubleshooting is performed on the related components.
Test Procedure
Driver's seat belt buckle switch circuit inspection
- Preparation
- Driver's seat belt buckle switch 2P connector: disconnected
- Procedure
- Turn the vehicle to the ON mode, then wait for 10 seconds.
- Normal Conditions
- DTC B0050-2B is not indicated.
Results
- If it is normal, there is a problem with the driver's seat belt buckle switch.
- If it is abnormal, there is a problem with other related components.