Driver's Seat Position Sensor Inspection
NOTE:
Since there is no direct method to test the component itself, troubleshooting is performed on the related components.
Test Procedure
Driver's seat position sensor circuit inspection
- Preparation
- Driver's seat position sensor 2P connector: disconnected
- Procedure
- Install a jumper wire between driver's seat position sensor 2P connector terminals No. 1 and No. 2.
- Turn the vehicle to the ON mode, then wait for 10 seconds.
(Disconnected)
Driver's seat position sensor 2P connector female terminals
- Normal Conditions
- DTC B00B5-13 is not indicated.
Results
- If it is normal, replace the driver's seat position sensor.
- If it is abnormal, there is a problem with the related components.