Communication (F-CAN D_H), Communication (F-CAN D_L) Open Wire Inspection

Test Procedure 

• Preparation
  • Gauge control module connector A (32P) : disconnected
  • CAN gateway 16P connector: disconnected
• Procedure
  • Perform the inspection according to the following table.

    			(Disconnected) Gauge control module connector A (32P) female terminals	(Disconnected) CAN gateway 16P connectorfemale terminals
    		IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
    	F-CAN D_H open wire inspection	OFF			There is less than 1 Ω
    	F-CAN D_L open wire inspection	OFF			There is less than 1 Ω

Results 

• If abnormal, there is a problem in the circuit.