Memorizing the Tire Pressure Sensor ID (2016 2017 2018 2019 2020 2021 2022): Procedure
- Tire Pressure Sensor ID - Memorize
Memorizing a Tire Pressure Sensor ID
All four sensor IDs must be memorized to the TPMS control unit whenever you do any of these actions:
- Replacing the keyless access/TPMS control unit.
- Replacing the tire pressure sensor.
- Substituting a known-good wheel with tire pressure sensor.
NOTE:
- To ensure the TPMS control unit memorizes the correct sensor ID, the vehicle with the new tire pressure sensor must be at least 10 ft (3 m) away from other vehicles that have sensors.
- When replacing the keyless access/TPMS control unit, use the HDS to memorize sensor IDs.
Memorizing a Tire Pressure Sensor ID Automatically
After rotating the tires or replacing a tire pressure sensor, drive the vehicle for at least 40 seconds at a speed of 15 mph (24 km/h) or more, and all the sensor IDs are memorized automatically.
NOTE: After the sensor IDs are memorized, reduce the pressure in all four tires to less than the appropriate specification, and check to see that the four tire indicators come on.
Memorize a Tire Pressure Sensor ID with the HDS
The HDS can memorize the sensor ID of a new tire pressure sensor or a previously memorized sensor ID.
1. Turn the vehicle to the OFF (LOCK) mode.
2. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
3. Turn the vehicle to the ON mode.
4. Make sure the HDS communicates with the vehicle and the TPMS control unit. If it does not communicate, go to the DLC circuit troubleshooting
5. Memorize the tire pressure sensor ID by following the screen prompts on the HDS.
NOTE:
- See the HDS Help menu for specific instructions.
- When replacing the keyless access/TPMS control unit, use the HDS to memorize sensor IDs.
- After the sensor IDs are memorized, reduce the pressure in all four tires to less than the appropriate specification, and check to see that the four tire indicators come on.
6. Turn the vehicle to the OFF mode.