Removal and Installation

NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

Battery Terminal - Disconnect
NOTE: Wait at least 3 minutes before starting work.
Front Seat - Remove

Front Seat Belt Lower Anchor Connector (Driver's Side) - Remove

Courtesy of HONDA, U.S.A., INC.

1. Slowly insert the seat belt disassembly tool plate (A) into holes (B) in the back of the lap connector cover (C).

NOTE: Make sure the seat belt disassembly tool plate is perpendicular to the lap connector cover.

Courtesy of HONDA, U.S.A., INC.

2. With the seat belt disassembly tool plate (A) still inserted in the lap connector cover (B), carefully insert the seat belt disassembly tool pin into the hole (C) in the lap connector cover, and unlock the lap connector by pushing in on the pin.

Courtesy of HONDA, U.S.A., INC.

3. While pulling the front seat belt (A) upward, remove the seat belt disassembly tool pin (B). As soon as you remove the pin from the lap connector (C), the anchor connector (D) will come off the lap connector.

B-Pillar Upper/Lower Trim - Remove
Front Seat Belt Upper Anchor Bolt - Remove

Fig 1: Front Seat Belt Upper Anchor Bolt With Torque Specifications
Courtesy of HONDA, U.S.A., INC.
Front Seat Belt Outer Lap Tensioner - Remove

Fig 2: Front Seat Belt Outer Lap Tensioner With Torque Specifications
Courtesy of HONDA, U.S.A., INC.

1. Disconnect the connector (A).
2. Remove the front seat belt outer lap tensioner (B).
Front Seat Belt Assembly - Remove

Fig 3: Front Seat Belt Assembly (Driver's Side) With Torque Specifications
Courtesy of HONDA, U.S.A., INC.

Fig 4: Front Seat Belt Assembly (Passenger's Side) With Torque Specifications
Courtesy of HONDA, U.S.A., INC.

1. Disconnect the connector(s) (A).
2. Remove the seat belt assembly (B).

All Removed Parts - Install

Courtesy of HONDA, U.S.A., INC.

1. Install the parts reverse order of removal.

NOTE: Assemble the bushing (A), the collar (B), and the toothed lock washer (C) on the upper anchor bolt (D) as shown.