SRS DTC Fx-11
DTC Fx-11 ("x" can be 0 thru 9 or A thru F) : Airbags and/or Tensioners Deployment Recorded
- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed .
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information .
- When any airbag or tensioners have deployed, go to Component Replacement/Inspection After Deployment .
| DTC Description | DTC |
|---|---|
DTC (SRS)
- DTC check
-1. Clear the DTCs with the HDS .
-2. Press the engine start/stop button to select the ON mode, then wait for 10 seconds.
-3. Check for DTCs with the HDS .
DTC Description DTC Is DTC F1-11, F2-11, F3-11, or F4-11 indicated?
DTC F1-11
Driver's airbag, left side curtain airbag, and/or driver's seat belt tensioner deployed.
DTC F2-11
Front passenger's airbag, right side curtain airbag, and/or front passenger's seat belt tensioner deployed.
DTC F3-11
Driver's side airbag, left side curtain airbag, and/or driver's seat belt tensioner deployed.
DTC F4-11
Front passenger's side airbag, right side curtain airbag, and/or front passenger's seat belt tensioner deployed.
NO DTC
Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures . If another DTC is indicated, troubleshoot the DTC.