DTC: U3000-51(Gauge Control Module)

DTC U3000-51  : Reprogramming Error

DTC (Gauge Control Module)

NOTE: 

• Before reprogramming the gauge control module, make sure the battery in the vehicle is fully charged, and connect a jumper battery (not a battery charger) to maintain system voltage.
• Never press the engine start/stop button to select the ACC or OFF mode, during the reprogramming. If there is a problem with the reprogramming, press the engine start/stop button to select the ON mode.

1. Problem verification

   -1. Clear the DTCs with the HDS.

   -2. Press the engine start/stop button to select the OFF mode and then the ON mode.

   -3. Check for DTCs with the HDS.

   DTC Description	DTC
   U3000-51 Reprogramming Error

   Is DTC U3000-51 indicated?

   YES 

   Reprogramming the gauge control module.

   NO 

   Intermittent failure, the system is OK at this time.