DTC P0501, P2159 (1.5 L Engine) (2020 2021)
DTC P0501 : Vehicle Speed Sensor A Out of Range DTC P2159 : Vehicle Speed Sensor B Out of Range
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | Confirmed DTC | Pending DTC |
|---|---|---|
| P0501 Vehicle Speed Sensor A Out of Range | ||
| P2159 Vehicle Speed Sensor B Out of Range |
DTC (PGM-FI)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Clear the VSA system DTCs with the HDS.
Clear DTC (VSA)
-4. Start the engine.
-5. Test-drive the vehicle under these conditions:
- Vehicle speed above 19 mph (30 km/h) for more than 30 seconds
Signal Current conditions Values Unit Vehicle Speed -6. Check the following VSA system DTCs with the HDS.
DTC Description DTC C0030-38 Magnetic Encoder (Left Front) Failure (Pulse Missing) C0031-14 Left Front Wheel Speed sensor Circuit Failure (Circuit Short To Ground or Open) C0031-62 Left Front Wheel Speed sensor Signal Compare Failure C0033-38 Magnetic Encoder (Right Front) Failure (Pulse Missing) DTC Description DTC C0034-14 Right Front Wheel Speed sensor Circuit Failure (Circuit Short To Ground or Open) C0034-62 Right Front Wheel Speed Sensor Signal Compare Failure Is DTC C0030-38, C0031-14, C0031-62, C0033-38, C0034-14, and/or C0034-62 indicated?
YES
The failure is duplicated. Go to the indicated VSA system DTC's troubleshooting .
NO
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the left-front wheel speed sensor, the right-front wheel speed sensor, the VSA modulator-control unit, the output shaft (countershaft) speed sensor, and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot .