DTC P00FE (1.5 L Engine) (2020 2021)

WARNING: This page is about a different car, the 2022 Honda Accord, 2021 Honda Accord, 2020 Honda Accord, 2019 Honda Accord, and 2018 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.

DTC P00FE : EVAP Vent Line Blockage

Special Tools Required

Vacuum Pump/Gauge, 0-30 inHg Snap-on YA4000A or equivalent, commercially available

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC Description	Confirmed DTC	Pending DTC
P00FE EVAP Vent Line Blockage

DTC (PGM-FI)

EVAP canister check

-1. Turn the vehicle to the OFF (LOCK) mode.

-2. Disconnect the fuel vent tube (A) from the EVAP canister (B).

Courtesy of HONDA, U.S.A., INC.

-3. Connect a hose (A) to the EVAP canister fuel vent tube port (B), and connect the vacuum pump/gauge, 0-30 inHg, to the hose as shown.

Courtesy of HONDA, U.S.A., INC.

-4. Turn the vehicle to the ON mode.

-5. Apply 1.3 kPa (0.4 inHg, 10 mmHg) of vacuum to the hose.

NOTE: Be careful not to exceed the vacuum. If you do, the FTP sensor can be damaged.

-6. Check the parameter (s) below with the HDS.

Signal	Current conditions
Signal	Values	Unit
FTP Sensor

Does the value of FTP Sensor change?

YES

Replace the fuel tank .

Replace the EVAP canister .