DTC P0069 (1.5 L Engine)
DTC P0069 : BARO Sensor Circuit Range/Performance Problem
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | Confirmed DTC | Pending DTC |
|---|---|---|
| P0069 BARO Sensor Circuit Range/Performance Problem |
DTC (PGM-FI)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Start the engine. Hold the engine speed at 3, 000 rpm without load (CVT in P or N, M/T in neutral) until the radiator fan comes on, then let it idle at least 5 seconds.
Test-drive the vehicle under these conditions:
- Engine speed above 1, 700 rpm
- REL TP Sensor above 42.2 deg
- Drive 6 seconds or more
Signal Current conditions Values Unit ECT Sensor 1 Engine Speed REL TP Sensor -5. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC P0069 BARO Sensor Circuit Range/Performance Problem Is DTC P0069 indicated?
YES
The failure is duplicated. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good PCM .
NO
Intermittent failure, the system is OK at this time. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot .