DTC U3000-49 (Electric Brake Booster Control Unit)
DTC U3000-49 : ECU Internal Malfunction
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| U3000-49 ECU Internal Malfunction |
DTC (Electric brake booster)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode, then wait 5 seconds or more.
NOTE: Do not open and close the driver's door.
-4. Turn the vehicle to the ON mode.
-5. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame U3000-49 ECU Internal Malfunction Is DTC U3000-49 indicated?
YES
The failure is duplicated. Check for loose terminals and poor connections in the electric brake booster 26P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the electric brake booster .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.