DTC P2820, P2821 (A/T)

WARNING: This page is about a different car, the 2022 Honda Accord, 2021 Honda Accord, 2020 Honda Accord, 2019 Honda Accord, and 2018 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.

DTC P2820 : Clutch Pressure Control Solenoid Valve A Stuck OFF DTC P2821 : Clutch Pressure Control Solenoid Valve A Stuck ON

NOTE: Before you troubleshoot, review the General Troubleshooting Information .

DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
P2820 Clutch Pressure Control Solenoid Valve A Stuck OFF
P2821 Clutch Pressure Control Solenoid Valve A Stuck ON

DTC (A/T)

Problem verification

-1. Raise the vehicle on a lift. Make sure it is securely supported, and allow all four wheels to rotate freely.

-2. Turn the vehicle to the ON mode.

-3. Clear the DTC with the HDS.

-4. Test-drive under these conditions:

DTC	Test Condition
P2820	Start the engine, disable the VSA . Run the vehicle in D position/mode, then slow down and stop the vehicle. While pressing the brake pedal, shift the transmission to R position/mode.
P2821	Start the engine, disable the VSA , and warm it up until the ATF temperature reaches 32 deg.F (0 deg.C) or more. Run the vehicle in 2nd gear with steady cruising with APP Sensor A (V) 1.4 V or lower.

-5. Check for Pending or Confirmed DTCs with the HDS.

DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
P2820 Clutch Pressure Control Solenoid Valve A Stuck OFF
P2821 Clutch Pressure Control Solenoid Valve A Stuck ON

Is DTC P2820 or P2821 indicated?

YES

The failure is duplicated. Replace the valve body assembly .

Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.