DTC P1855 (CVT (TCM))
WARNING: This page is about a different car, the 2022 Honda Accord, 2021 Honda Accord, 2020 Honda Accord, 2019 Honda Accord, and 2018 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.
DTC P1855 : Inclination Sensor Circuit Range/Performance
NOTE:
- Before you troubleshoot, review the General Troubleshooting Information .
- This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P1855 Inclination Sensor Circuit Range/Performance |
DTC (CVT)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Test-drive the vehicle until the OBD status of DTC P1855 changes.
-4. Monitor the OBD STATUS for DTC P1855 in the DTCs MENU with the HDS.
DTC Description OBD STATUS P1855 Inclination Sensor Circuit Range/Performance Does the HDS indicate FAILED?
YES
The failure is duplicated. Replace the SRS unit .
NO
If the HDS indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections and loose terminals between the SRS unit and the TCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot. If the HDS indicates NOT COMPLETED, go to step 1-3 and recheck.