DTC P0982, P0983 (A/T)
DTC P0982 : Shift Solenoid Valve D Circuit Low DTC P0983 : Shift Solenoid Valve D Circuit High
NOTE: Before you troubleshoot, review the General Troubleshooting Information .
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P0982 Shift Solenoid Valve D Circuit Low | |||
| P0983 Shift Solenoid Valve D Circuit High |
DTC (A/T)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Test-drive under these conditions:
DTC Test Condition P0982 Start the engine. P0983 - Start the engine.
- While pressing the brake pedal, shift the transmission to D position/mode.
-4. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P0982 Shift Solenoid Valve D Circuit Low P0983 Shift Solenoid Valve D Circuit High Is DTC P0982 or P0983 indicated?
YES
The failure is duplicated. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good TCM , then recheck. If this DTC goes away and the TCM was substituted, replace the original TCM .
NO
Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals between shift solenoid valve D and the TCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.