P07A4, P07A5 (A/T)
WARNING: This page is about a different car, the 2022 Honda Accord, 2021 Honda Accord, 2020 Honda Accord, 2019 Honda Accord, and 2018 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.
DTC P07A4 : Clutch C2 Stuck OFF
DTC P07A5 : Clutch C2 Stuck ON
NOTE: Before you troubleshoot, review the General Troubleshooting Information .
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P07A4 Clutch C2 Stuck OFF | |||
| P07A5 Clutch C2 Stuck ON |
DTC (A/T)
- Problem verification
-1. Raise the vehicle on a lift. Make sure it is securely supported, and allow all four wheels to rotate freely.
-2. Turn the vehicle to the ON mode.
-3. Clear the DTC with the HDS.
-4. Test-drive under these conditions:
DTC Test Condition P07A4 - Start the engine, disable the VSA .
- Run the vehicle from 1st gear to 2nd gear.
P07A5 - Start the engine, disable the VSA , and wait for at least 10 seconds in P position/mode.
- Run the vehicle in 2nd gear with steady cruising.
-5. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P07A4 Clutch C2 Stuck OFF P07A5 Clutch C2 Stuck ON Is DTC P07A4 or P07A5 indicated?
YES
The failure is duplicated. Replace the valve body assembly .
NO
Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.