LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2020 >> ILX >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (VSA System - DTC Diagnostics (Except Hybrid)) >> DTC Troubleshooting >> DTC C1C22-62 (A/T/CVT)

DTC C1C22-62 (A/T/CVT)

WARNING: This page is about a different car, the 2022 Honda Accord, 2021 Honda Accord, 2020 Honda Accord, 2019 Honda Accord, and 2018 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.

DTC C1C22-62  : Neutral Sensor Failure

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC Description DTC
C1C22-62 Neutral Sensor Failure  

DTC (VSA)

  1. DTC check

    -1. Turn the vehicle to the ON mode.

    -2. Clear the DTC with the HDS.

    -3. Turn the vehicle to the OFF (LOCK) mode.

    -4. Test-drive the vehicle at 19 mph (30 km/h) or more for 60 seconds or more.

    NOTE:  Drive the vehicle on the road, not on a lift.

    -5. Check for DTCs with the HDS.

    DTC Description DTC
    U0029-00 CAN Communication Failure (Bus OFF Ch 1)  
    U0101-00 CAN Communication Failure with PCM/TCM  
    C1C22-62 Neutral Sensor Failure  

    Is DTC C1C22-62 indicated?

    YES (A/T)

    If DTC C1C22-62 is only indicated, go to step 2.

    YES (CVT)

    If DTC C1C22-62 is only indicated, go to step 3.

    YES 

    If DTC U0029-00 or U0101-00 are also indicated, go to U0029-00  or U0101-00 .

    NO 

    Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .

  2. A/T system parameter check

    -1. Check the parameter (s) below with the HDS.

    Signal Current conditions
    Values Unit
    N Switch    

    Does the parameter change when shifting the transmission to N position/mode, or shifting from the N position/mode to a different gear position other than reverse?

    YES 

    Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit .

    NO 

    Check the A/T system DTC .

  3. CVT system parameter check

    -1. Check the parameter (s) below with the HDS.

    Signal Current conditions
    Values Unit
    A/T N Switch    

    Does the parameter change when shifting the transmission to N position/mode, or shifting from the N position/mode to a different gear position other than reverse?

    YES 

    Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit .

    NO 

    Check the transmission range switch .

scientia non olet · About LEMON Manuals