DTC C1130-62

WARNING: This page is about a different car, the 2022 Honda Accord, 2021 Honda Accord, 2020 Honda Accord, 2019 Honda Accord, and 2018 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.

DTC C1130-62 : Clutch Pedal Stroke Sensor CPS1/CPS2 Incorrect Voltage Correlation

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC Description	DTC
C1130-62 Clutch Pedal Stroke Sensor CPS/CPS2 Incorrect Voltage Correlation

DTC (VSA)

DTC check

-1. Turn the vehicle to the ON mode.

-2. Clear the DTC with the HDS.

-3. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.

-4. Check for DTCs with the HDS.

DTC Description	DTC
C1130-62 Clutch Pedal Stroke Sensor CPS/CPS2 Incorrect Voltage Correlation
C1131-14 Clutch Pedal Stroke Sensor CPS Open or Short

Is DTC C1130-62 indicated?

YES

If DTC C1130-62 is only indicated, go to step 2.

YES

If DTC C1131-14 is also indicated, go to DTC C1131-14 .

Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .

Clutch pedal stroke sensor check (substitution)

-1. Turn the vehicle to the OFF (LOCK) mode.

-2. Substitute a known-good clutch pedal assembly .

-3. Turn the vehicle to the ON mode.

-4. Clear the DTC with the HDS.

-5. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.

-6. Check for DTCs with the HDS.

DTC Description	DTC
C1130-62 Clutch Pedal Stroke Sensor CPS/CPS2 Incorrect Voltage Correlation

Is DTC C1130-62 indicated?

YES

Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit .

Replace the original clutch pedal assembly .