DTC C1130-54, C1130-76
DTC C1130-54 : Clutch Stroke Sensor Not Calibrated DTC C1130-76 : Clutch Pedal Stroke Sensor Mount Position Error
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC |
|---|---|
| C1130-54 Clutch Stroke Sensor Not Calibrated | |
| C1130-76 Clutch Pedal Stroke Sensor Mount Position Error |
DTC (VSA)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
-4. Check for DTCs with the HDS.
DTC Description DTC C1130-54 Clutch Stroke Sensor Not Calibrated C1130-76 Clutch Pedal Stroke Sensor Mount Position Error Is DTC C1130-54 or C1130-76 indicated?
YES
The failure is duplicated. Go to step 2.
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .
- Clutch pedal stroke sensor check (substitution)
-1. Turn the vehicle to the OFF (LOCK) mode.
-2. Substitute a known-good clutch pedal assembly .
-3. Turn the vehicle to the ON mode.
-4. Clear the DTC with the HDS.
-5. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
-6. Check for DTCs with the HDS.
DTC Description DTC C1130-54 Clutch Stroke Sensor Not Calibrated C1130-76 Clutch Pedal Stroke Sensor Mount Position Error Is DTC C1130-54 or C1130-76 indicated?
YES
Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit .
NO