DTC C1000-94

WARNING: This page is about a different car, the 2022 Honda Accord, 2021 Honda Accord, 2020 Honda Accord, 2019 Honda Accord, and 2018 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.

DTC C1000-94 : ABS/VSA Activation Time Too Long

NOTE:

Before you troubleshoot, review the general troubleshooting information .
A wheel bearing that is installed backwards can cause this DTC.

DTC Description	DTC
C1000-94 ABS/VSA Activation Time Too Long

DTC (VSA)

Problem verification

-1. Turn the vehicle to the ON mode.

-2. Clear the DTC with the HDS.

-3. Turn the vehicle to the OFF (LOCK) mode.

-4. Test-drive the vehicle at 31 mph (50 km/h) or more for 30 seconds or more.

NOTE: Drive the vehicle on the road, not on a lift.

-5. Check for DTCs with the HDS.

DTC Description	DTC
C1000-94 ABS/VSA Activation Time Too Long

Is DTC C1000-94 indicated?

YES

Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit .

Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .