DTC C0062-62, C0062-F0

WARNING: This page is about a different car, the 2022 Honda Accord, 2021 Honda Accord, 2020 Honda Accord, 2019 Honda Accord, and 2018 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.

DTC C0062-62 : Longitudinal Acceleration Sensor Failure (Signal Compare Failure)DTC C0062-F0 : Longitudinal Acceleration Sensor Malfunction

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC Description	DTC
C0062-62 Longitudinal Acceleration Sensor Failure (Signal Compare Failure)
C0062-F0 Longitudinal Acceleration Sensor Malfunction

DTC (VSA)

DTC check

-1. Clear the DTC with the HDS.

-2. Turn the vehicle to the OFF (LOCK) mode.

-3. Test-drive the vehicle at 31 mph (50 km/h) or more for 6 minutes, then stop. Repeat this step for 4 times.

NOTE: Drive the vehicle on the road, not on a lift.

-4. Check for DTCs with the HDS.

DTC Description	DTC

Is DTC C0062-62 or C0062-F0 indicated?

YES

Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the SRS unit .

If any other DTCs are indicated, go to the indicated DTCs troubleshooting.

Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .