DTC B0050-F0 (VSA Control Unit)

WARNING: This page is about a different car, the 2022 Honda Accord, 2021 Honda Accord, 2020 Honda Accord, 2019 Honda Accord, and 2018 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.

DTC B0050-F0 : Driver's Seat Belt Buckle Switch Malfunction

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC Description	DTC
B0050-F0 Driver's Seat Belt Buckle Switch Malfunction

DTC (VSA)

SRS DTCs check

-1. Turn the vehicle to the ON mode.

-2. Check for SRS DTCs with the HDS.

DTC Description	DTC

DTC (SRS)

Are any DTCs indicated?

YES

Go to indicated DTCs troubleshooting .

Go to step 2.

Problem verification

-1. Clear the DTC with the HDS.

-2. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.

-3. Check for DTCs with the HDS.

DTC Description	DTC
B0050-F0 Driver's Seat Belt Buckle Switch Malfunction

Is DTC B0050-F0 indicated?

YES

Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit .

Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .