DTC B1C68 (Ventilated Seat Control Unit)
WARNING: This page is about a different car, the 2022 Honda Accord, 2021 Honda Accord, 2020 Honda Accord, 2019 Honda Accord, and 2018 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.
DTC B1C68 : Driver's Heater Not Heating
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A
.
| DTC Description | DTC |
|---|---|
| B1C68 Driver's heater not heating |
DTC (Ventilated Seat Control Unit)
- Problem verification
-1. Clear the DTCs with the HDS.
-2. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.
-3. Turn the driver's seat heater switch ON.
-4. Check for DTCs with the HDS.
DTC Description DTC B1C68 Driver's heater not heating Is DTC B1C68 indicated?
YES
Go to step 2.
NO
Intermittent failure, the system is OK at this time. Check for loose or poor connections.
- DTC check
-1. Check for DTCs with the HDS.
DTC Description DTC B1C55 Driver's heater thermistor circuit open B1C56 Driver's heater thermistor circuit short B1C60 Driver's heater current abnormal high B1C61 Driver's heater current abnormal low Are DTCs B1C55, B1C56, B1C60, and/or B1C61 indicated?
YES: DTC B1C55 is indicated
Go to DTC B1C55 troubleshooting .
YES: DTC B1C56 is indicated
Go to DTC B1C56 troubleshooting .
YES: DTC B1C60 is indicated
Go to DTC B1C60 troubleshooting .
YES: DTC B1C61 is indicated
Go to DTC B1C61 troubleshooting .
NO