Left/Right Channel ID

Do this test to confirm proper channel routing.

1. Insert the audio Diagnostic CD (07AAZ-SDBA100) into the audio-navigation unit or the audio unit.

2. Play track No. 1 (left, both, right channel ID) at a normal, or slightly higher than normal, volume level.The voice should be audible only from the channel or channels when indicated.

• If the channel ID is correct for each side, go to Phase Test.
• If the channel ID is not correct, check for:
• • -

    Shorted speaker wire

  • -

    Open in speaker wire

  • -

    Shorted speaker

  • -

    Loose connection or poor pin fit

  • -

    Faulty audio-navigation unit or audio unit

  • -

    Faulty stereo amplifier