How to Clear DTCs
NOTE: Make sure the battery is fully charged before you begin.
1. Turn the vehicle to the OFF (LOCK) mode.
2. Connect the HDS to the data link connector (DLC) (A).
3. Turn the vehicle to the ON mode.
4. Make sure the HDS communicates with the vehicle and the E-pretensioner unit. If it does not communicate, go to the DLC circuit troubleshooting
5. From SRS of the HDS Main Menu, select E-PT, then clear the DTC(s) by following the screen prompts on the HDS.
6. Turn the vehicle to the OFF (LOCK) mode, then wait for 10 seconds.