DTC U3000-49

DTC U3000-49  : Multipurpose Camera Unit Internal Electronic Failure

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC (IDAS)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode.

   -4. Turn the vehicle to the ON mode, then wait for at least 5 seconds.

   -5. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame
   U3000-49 Multipurpose Camera Unit Internal Electronic Failure

   Is DTC U3000-49 indicated?

   YES 

   The failure is duplicated. Go to step 2.

   NO 

   Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.

2. Multipurpose camera unit check (update)

   -1. Update the multipurpose camera unit if it does not have the latest software .

   -2. Turn the vehicle to the OFF (LOCK) mode.

   -3. Turn the vehicle to the ON mode, then wait for at least 5 seconds.

   -4. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame
   U3000-49 Multipurpose Camera Unit Internal Electronic Failure

   Is DTC U3000-49 indicated?

   YES 

   Check for loose terminals in the multipurpose camera unit 20P connector. If the multipurpose camera unit was updated and the symptom/indication is still present, replace the multipurpose camera unit .

   NO 

   Troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTC's troubleshooting.