DTC P2583-64

DTC P2583-64  : Millimeter Wave Radar Aiming Error

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC (IDAS)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode.

   -4. Test-drive the vehicle on a straight road at speeds 25 mph (40 km/h) or more for 5 minutes with the ACC activated.

   NOTE:  Drive the vehicle on the road, not on a lift.

   -5. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame
   P2583-64 Millimeter Wave Radar Aiming Error

   Is DTC P2583-64 indicated?

   YES 

   The failure is duplicated. Go to step 2.

   NO 

   Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.

2. Millimeter wave radar installation check

   -1. Remove the front bumper .

   -2. Check the installation of the millimeter wave radar and the bracket.

   Is the installation OK?

   YES 

   Go to step 3.

   NO 

   Reinstall or replace the part that has a problem, then go to step 3.

3. Millimeter wave radar aiming

   -1. Install the front bumper .

   -2. Aim the millimeter wave radar .

   -3. Turn the vehicle to the ON mode.

   -4. Clear the DTC with the HDS.

   -5. Turn the vehicle to the OFF (LOCK) mode.

   -6. Test-drive the vehicle on a straight road at speeds 25 mph (40 km/h) or more for 5 minutes with the ACC activated.

   NOTE:  Drive the vehicle on the road, not on a lift.

   -7. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame
   P2583-64 Millimeter Wave Radar Aiming Error

   Is DTC P2583-64 indicated?

   YES 

   Check for loose or poor connections. If OK, replace the millimeter wave radar .

   NO 

   Troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTC's troubleshooting.