DTC B2A60-54

DTC B2A60-54  : Static Camera Aiming Incomplete

NOTE: 

• Before you troubleshoot, review the general troubleshooting information .
• If the multipurpose camera unit or the windshield is removed or replaced, you must aim it, otherwise DTC B2A60-54 is stored even if the system is OK.

DTC (IDAS)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode, then the ON mode.

   -4. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame
   B2A60-54 Static Camera Aiming Incomplete

   Is B2A60-54 indicated?

   YES 

   The failure is duplicated. Do the static camera aiming .

   NO 

   Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.