DTC B0029-12: Short to Power in the Right Side Curtain Airbag First Inflator (2018-19)

NOTE: 

Before doing this troubleshooting procedure: 

• Find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components of the correct part number, and that they were properly installed - Refer to: SRS Component Replacement/Inspection After Deployment .
• Review SRS Precautions and Procedures .
• Review General Troubleshooting Information
• Review information pertaining to 12 Volt Battery Terminal Disconnection and Reconnection

Before replacing the SRS unit: 

• Check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS unit software , and retest.

DTC (SRS)

1. Problem verification

   -1. Clear the DTCs with the HDS.

   - 2. Turn the vehicle to the ON mode, then wait for 10 seconds.

   - 3. Check for DTCs with the HDS.

   DTC Description
   B0029-12 Short to power in the right side curtain airbag first inflator

   Is DTC B0029-12 indicated?

   YES 

   The failure is duplicated. Go to step 2.

   NO 

   Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.

2. Shorted wire check (RCA1+, RCA1- lines to power) 1

   -1. Turn the vehicle to the OFF (LOCK) mode.

   - 2. Disconnect the negative cable from the 12 volt battery, then wait at least 3 minutes.

   - 3. Remove the headliner.

   - 4. Disconnect the following connector.

   Right side curtain airbag inflator 2P connector (on the right side wire harness)

   - 5. Reconnect the negative cable from the 12 volt Battery.

   - 6. Turn the vehicle to the ON mode, then clear the DTC.

   - 7. Check for DTCs with the HDS.

   Is DTC B0029-12 indicated?

   YES 

   Go to step 3.

   NO 

   Short to power in the right side curtain airbag inflator; replace the right side curtain airbag , then clear the DTC.

3. Shorted wire check (RCA1+, RCA1- lines to power) 2

   -1. Turn the vehicle to the OFF (LOCK) mode.

   - 2. Disconnect the negative cable from the 12 volt battery, then wait at least 3 minutes.

   - 3. Disconnect the following connector.

   SRS unit connector B (39P)

   - 4. Reconnect the negative cable from the 12 volt Battery. Then wait at least 3 minutes.

   - 5. Turn the vehicle to the ON mode.

   - 6. Measure the voltage between test points 1 and 2.

   Test condition	Vehicle ON mode
   	SRS unit connector B (39P): disconnected
   	Right side curtain airbag inflator 2P connector (on the right side wire harness): disconnected
   Test point 1	SRS unit connector B (39P) No. 7 - Refer to: SRS Unit Connector for Inputs and Outputs
   Test point 2	Body ground

   Test point 1	SRS unit connector B (39P) No. 8 - Refer to: SRS Unit Connector for Inputs and Outputs
   Test point 2	Body ground

   Is there 0.2 V or less?

   YES 

   The RCA1+ and RCA1- wires are OK. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting or replace the SRS unit - Refer to: SRS Unit Removal and Installation .

   NO 

   Short to power in the right side wire harness; replace the right side wire harness, then clear the DTC.