Parking And Back-Up Sensor Switch Test: Test

Driver's Outer Dashboard Lower Cover - Remove
Parking and Back-Up Sensor Switch - Test
NOTE:
Mounting position of the parking and back-up sensor switch (A) is changed depending on the model.

1. Check the parking and back-up sensor switch according to the table.
NOTE:
- When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
- Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
Courtesy of HONDA, U.S.A., INC.

Courtesy of HONDA, U.S.A., INC.

2. If the result is not as specified, replace the parking and back-up sensor switch .
All Removed Parts - Install

1. Install the parts in the reverse order of removal.