How to Read DTCs
NOTE: Make sure the battery is fully charged before you begin.
1. Turn the vehicle to the OFF (LOCK) mode.
2. Connect the HDS to the data link connector (DLC) (A).
3. Turn the vehicle to the ON mode.
4. Make sure the HDS communicates with the vehicle. If it does not communicate, go to the DLC circuit troubleshooting
5. From SRS/E-PT in the HDS Main Menu, select E-PT, then check for E-pretensioner DTCs.
6. Read and record the DTC.
NOTE: Do not clear the DTC until instructed by the troubleshooting procedure.
7. Turn the vehicle to the OFF (LOCK) mode.
8. Do the troubleshooting procedure for the DTC.