DTC C0061-F0
DTC C0061-F0 : Lateral Acceleration Sensor (Subfault) Fault Detection By Source Module
NOTE:
- Before you troubleshoot, review the general troubleshooting information .
- These DTCs are recorded when the multipurpose camera unit receives the VSA modulator-control unit failure information via the F-CAN.
- If a DTC is recorded again after it is cleared with the HDS, refer to the DTC troubleshoot for the VSA system .
- The functions of the integrated driver support system that will be temporarily canceled when this DTC is recorded can be confirmed with the DTC troubleshooting index .
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| C0061-F0 Lateral Acceleration Sensor (Subfault) Fault Detection By Source Module |
DTC (IDAS)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode.
-4. Turn the vehicle to the ON mode, then wait for at least 6 seconds.
-5. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame C0061-F0 Lateral Acceleration Sensor (Subfault) Fault Detection By Source Module Is DTC C0061-F0 indicated?
YES
The failure is duplicated. Go to the indicated DTC's troubleshooting in the VSA system .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.